Turning Raspberry PI GPIO off and on base on temper device value
python3 setup.py installusage: __main__.py [-h] [-rpc] [-v] [-stop] [-off_first]
[--lcd {sainsmart_charlcd_led,adafruit_charlcd_rgb,adafruit_charlcd_mono}]
[--pin PIN] [--off OFF] [--on ON] [--rpc_listen RPC_LISTEN]
[--rpc_port RPC_PORT]
optional arguments:
-h, --help show this help message and exit
-rpc Start rpc server
-v, --verbose Log verbosity
-stop Cleanup on stop service
-off_first Check OFF condition first, then ON condition
--lcd {sainsmart_charlcd_led,adafruit_charlcd_rgb,adafruit_charlcd_mono}
Use I2C LCD 16x2 to show status
--pin PIN GPIO Pin
--off OFF Pin Off condition, format: <temp|hum>:<eq|lt|lte|gt|gt
e>:<value>:[or|and|xor|nand|nor|xnor]
--on ON Pin On condition, format: <temp|hum>:<eq|lt|lte|gt|gte
>:<value>:[or|and|xor|nand|nor|xnor]
--rpc_listen RPC_LISTEN
Listen address, default all 0.0.0.0
--rpc_port RPC_PORT Listen port, default 15555
--pin can be specified multiple time, useful for giving signal when condition reach and show current state e.g using RGB LED
--on or --off condition can be specified multiple time, default logic AND will be use between condition if empty
Condition will be check by priority, default is ON condition then OFF condition. If first condition is reach, the second one will be skip until next iteration. Use -off_first to check OFF condition first.
If multiple temper device installed, average value from those device will be use for comparison
--lcd is optional to show temper status in the installed lcd, currently only support adafruit and sainsmart
Copy rpioalert.service to /etc/systemd/system/rpioalert.service Change the user inside this file to the user in temper group, and enable systemd
sudo systemctl enable rpioalert.service
sudo systemctl daemon-reload
sudo systemctl start rpioalert.service