Issues: protoloft/klipper_z_calibration
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. Weβll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Author
Label
Projects
Milestones
Assignee
Sort
Issues list
Disable "Save Z Endstop" and "Save Z Probe" when print completes.
#142
opened May 11, 2024 by
karlfife
Move from clearance to safe_z_home when no [probe] section defined
#139
opened Mar 22, 2024 by
DaStivi
Automatic detection of the offset between nozzles of different tools.
#134
opened Jan 7, 2024 by
Octopusmode
Is it possible to have a dedicated Z Switch pin instead of just using the Probe Pin?
#133
opened Jan 6, 2024 by
wil-sys
If no Bed Mesh, it uses Z endstop height as Zero Position
#132
opened Dec 20, 2023 by
maxime-granger
Internal error on command:"CALIBRATE_Z" Internal error on command:"BASE_CALIBRATE_Z"
#105
opened Jun 27, 2023 by
BelgarionNL
ProTip!
Type g i on any issue or pull request to go back to the issue listing page.