Node Security helps you keep your node applications secure. With Node Security you can:
- Make use of the CLI tool to help identify known vulnerabilities in your own projects.
- Get access to Node Security news and information from the ^lift team.
- To install the Node Security command line tool:
npm install -g nsp - Then run
nsp --helpto find out more.
The Node Security CLI supports adding exceptions. These are advisories that you have evaluated and personally deemed unimportant for your project.
In order to leverage this capability, create a .nsprc file in the root of your project with content like the following:
{
"exceptions": ["https://nodesecurity.io/advisories/12"]
}The URLs used in the array should match the advisory link that the CLI reports. With this in place, you will no longer receive warnings about any advisories in the exceptions array.
Be careful using this feature. If you add code later that is impacted by an excluded advisory, Node Security has no way of knowing. Keep a careful eye on your exceptions.
The Node Security CLI has proxy support by using proxy-agent.
The currently implemented protocol mappings are listed in the table below:
| Protocol | Example |
|---|---|
http |
http://proxy-server-over-tcp.com:3128 |
https |
https://proxy-server-over-tls.com:3129 |
socks(v5) |
socks://username:[email protected]:9050 (username & password are optional) |
socks5 |
socks5://username:[email protected]:9050 (username & password are optional) |
socks4 |
socks4://some-socks-proxy.com:9050 |
pac |
pac+http://www.example.com/proxy.pac |
To configure the proxy set the proxy key in your .nsprc file. This can be put in the root of your project or in your home directory.
{
"proxy": "http://127.0.0.1:8080"
}codeclimate-nodesecurity is a Code Climate engine that wraps the Node Security CLI. You can run it on your command line using the Code Climate CLI, or Code Climate's hosted analysis platform.
Note that this engine only works if your code has a npm-shrinkwrap.json file committed.
First, build this repo with docker
git clone [email protected]:nodesecurity/nsp
cd nsp
docker build -t codeclimate/codeclimate-nodesecurity .
Install the codeclimate CLI
brew tap codeclimate/formulae
brew install codeclimate
Go into your project's directory and enable codeclimate
codeclimate init
Then edit .codeclimate.yml to add the engine like so
---
engines:
nodesecurity:
enabled: true
exclude_paths: []And finally run it
codeclimate analyze --dev
Node Security (+) is brought to you by ^lift security.
Copyright (c) 2015 by ^Lift Security
Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,
WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and
limitations under the License.