InkArt

Display grayscale art on Inkplate!

Works with Inkplate 6 and Inkplate 10.

Inkplate 6	Inkplate 10

WebApp

Home	Upload	File Manager

Display	Settings	Information

Hardware requirement

• Inkplate 6 or Inkplate 10
• microSD card
• LiPo battery

Build firmware and web app

Firmware

PlatformIO is used for firmware development. To build it, install PlatformIO and run the following command.

Inkplate 6

cd firmware
pio run -e inkplate-6

Inkplate 10

cd firmware
pio run -e inkplate-10

Web App

node.js is used for web app development. To build it, install node.js and run the following command.

cd web-app
npm install
npm run build

The build artifacts are output to web-app/dist

Setup

First, burn web-app to Inkplate. Connect Inkplate to your PC and run the following command.

• Inkplate 6: pio run -e inkplate-6 -t uploadfs
• Inkplate 10: pio run -e inkplate-10 -t uploadfs

Next, burn the built firmware to Inkplate.

• Inkplate 6: pio run -e inkplate-6 -t upload
• Inkplate 10: pio run -e inkplate-10 -t upload

If you have any questions or need more information about build/burn firmware with PlatformIO, please search it with DuckDuckGo yourself.

How to use

1. Power on an Inkplate. Inkplate boots up to setup mode and launches the access point.
2. Connect to the access point shown on the Inkplate and access the web app.
3. Configure settings of device orientation, display area and update interval if you need.
4. Upload the image you want to display.
5. Touch all the touchpads on Inkplate or restart from web app.
6. Wait a few seconds until an image is displayed. After that Inkplate goes into deep sleep soon.
7. Inkplate will wake up and refresh the image after the update interval elapses.

How to start development

Open InkArt.code-workspace with VS Code.

License

Licensed under MIT license.