-
Notifications
You must be signed in to change notification settings - Fork 26
Hybrid Working Mode
Simone C edited this page Feb 16, 2018
·
1 revision
This is the native working mode for FABlin and roughly corresponds to the normal working setup of a stock Marlin firmware. It is a combination of the FFF and CNC modes.
Tool | Heater | Temperature |
---|---|---|
Head | Available | Available |
Bed | Available | Available |
Tool | Servo |
---|---|
Head | Available |
Command | Description |
---|---|
M718 |
24VDC head heater ON |
M719 |
24VDC head heater OFF |
The FABlin architecture:
- Interface - G code commands, Error codes
- Application - Add-ons, G-code intepreter, Planner, Working modes
- Middleware - Servo, Stepper, Temperature
- MCU subsystems - ADC, GPIO, PWM
- Hardware - IO table