You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When I slice a (particular) part, the internal bridge infill does not reach far enough to the perimeter (on one side only). as such the infill "drops" down and leaves gaps in the surfaces above. Reason that it is not touching the perimeter is (probably) that there is a wall above this layer. As there is only sparse infill below, the infill layers have nothing to connect to or "lay on top of"
Project file & How to reproduce
cradle.zip
Slice with 2 perimeters (0.6mm), 3 solid bottom layers and 25% infill. Check layer 8 (and 9)
Version
2.5.59.11 and 2.5.59.12
Operating system
Win 11 pro
Printer model
RatRig V-Core 3.1 running RatOS 2.1 (Klipper)
The text was updated successfully, but these errors were encountered:
What happened?
When I slice a (particular) part, the internal bridge infill does not reach far enough to the perimeter (on one side only). as such the infill "drops" down and leaves gaps in the surfaces above. Reason that it is not touching the perimeter is (probably) that there is a wall above this layer. As there is only sparse infill below, the infill layers have nothing to connect to or "lay on top of"
Project file & How to reproduce
cradle.zip
Slice with 2 perimeters (0.6mm), 3 solid bottom layers and 25% infill. Check layer 8 (and 9)
Version
2.5.59.11 and 2.5.59.12
Operating system
Win 11 pro
Printer model
RatRig V-Core 3.1 running RatOS 2.1 (Klipper)
The text was updated successfully, but these errors were encountered: