Configuration of libfabric+infiniband+ipoib #7885
Replies: 3 comments
-
please share ifconfig info for both sides. |
Beta Was this translation helpful? Give feedback.
-
Also please check the output of |
Beta Was this translation helpful? Give feedback.
-
Hi, sorry for the delayed response, I was on vacations. Right now the ibv_devinfo shows that the PORT is not ACTIVE (just INIT(2)). This was not the case before when I made the post, so right now there exist a more fundamental problem. I'll fix it and get our system in a proper state and if the original problem persists, I'll get back to you ASAP. Thanks again, |
Beta Was this translation helpful? Give feedback.
-
Hi,
I followed the instruction of the vendor in order to setup a testbed for our libfabric development and I get a "connection refused" error. I'm pretty sure this is not a problem with libfabric but a misconfiguration of the system, so I would appreciate an advice of how to debug this.
fi_pingpong works in general but when I chose
-p "verbs;ofi_rxm"
it returnsfi_getinfo(): util/pingpong.c:1433, ret=-61 (No data available)
.For the destination address I write the ip assigned to the infiniband interface by ipoib. So my fi_pingpong client invocation looks like this:
and ifconfig returns:
This is the log of the server:
and this is the log of the client
Do you have a hint about where to look for problems?
Thanks,
Aram
Beta Was this translation helpful? Give feedback.
All reactions