TWO DALY BMS with Influx/Grafana does not show correct values

[cyborgxxl]

I hope someone here can help me. I am using two identical DALY BMS and would like to write the data collected there into an influxdb for Grafana.

My mpp-solar.conf currently looks like this:

[SETUP]
pause=10
mqtt_broker=localhost

[DALYBMS1]
model=DALY8S200A
protocol=DALY40
port=/dev/ttyUSB1
baud=9600
command=SOC,cellVoltages,cellTemperatures,cellMinMaxVoltages,cellMinMaxTemps,mosStatus,status
tag=dalybms1
outputs=influx2_mqtt

[DALYBMS2]
model=DALY8S200A
protocol=DALY40
port=/dev/ttyUSB0
baud=9600
command=SOC,cellVoltages,cellTemperatures,cellMinMaxVoltages,cellMinMaxTemps,mosStatus,status
tag=dalybms2
outputs=influx2_mqtt

The problem is that in Grafana I cannot select the data separately according to BMS.

So when I call mpp-solar like this: mpp-solar -C /etc/mpp-solar/mpp-solar.conf --daemon

Then it looks like this in Grafana:

Am I doing something wrong here? It works wonderfully with one BMS, but no longer with two.

[DMIINC]

You have to select correct Tag in "FROM" line. mpp-solar where = dalybms1

[cyborgxxl]

But there is only mpp-solar and nothing else.

[cyborgxxl]

Oh, I'm still a bloody beginner, it seems. I found it. Thank you very much!!!

[DMIINC]

You are welcome. Where are you using these batteries?

[cyborgxxl]

I use these batteries in my 20kwh solar battery array.