-
Notifications
You must be signed in to change notification settings - Fork 358
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
T-Beam Communication problem #878
Comments
I have found a temporary solution, but it is not satisfying. What I have found out so far. When I run The log also says: Now I have written a script that resets the TTGO T-Beam: Now it works fine, but what I don't know is why I need to reset the T-Beam. |
You should repost this over on the current fork. https://github.com/b3nn0/stratux/issues |
Stratux version: v1.6r1-eu029
Stratux config:
SDR
GPS
type:
TTGO T-Beam ESP32 868MHz LoRaWAN NEO-M8N GPS Board with SX1262 Chip.
Fw flashed via Stratux with the command: sudo /opt/stratux/ogn/install-ogntracker-firmware-pi.sh sx1262
lsusb: Bus 001 Device 003: ID 1a86:55d4 QinHeng Electronics USB Single Serial
45w USB-C Power Supply and also 5v 4A Power Source
tried different Cables
EFB app and version: (e.g., WingX Pro7 8.6.2)
EFB platform: (e.g., iOS 9.2)
EFB hardware: (e.g., iPad Mini 2)
Description of your issue:
Get the Error: USB Serial IN (Not communicating) on the Status Page.
after clicking the RST button on the T-Beam Board, the communication is established. but only until the next power cycle.
If possible, enable "Replay Logs", reproduce the problem, and provide a copy of the logs in http://192.168.10.1/logs/stratux/ and http://192.168.10.1/logs/stratux.log.
The text was updated successfully, but these errors were encountered: