1 Door (with multi channel device)

⚠️ It is important to have:

• channel 0 connected to the 'open' motor and
• channel 1 connected to the 'close' motor

When fully opening/closing the door, the plugin will turn the appropriate channel ON for the duration of the specified operationTime and then turn the channel OFF. When opening/closing the door to a custom position (e.g. 50% open) then the plugin will calculate the time that the channels need to be ON based on the operationTime.

The operationTime is defined in deciseconds so time how long it takes to open/close the door and multiply this by ten.

Since it is impossible for the device to report the correct position of the door to Homebridge, the plugin relies on a cached state which changes each time the door is opened/closed. There may be times when this becomes out of sync. If this happens, please make sure the door is fully closed, then remove the accessory from the Homebridge cache. The accessory will be added again with a CLOSED status which will match the door.

A configuration example:

[
   {
      "deviceId": "10009553c8",
      "type": "door",
      "operationTime": 50
   }
]

• If using the Homebridge UI, it's easier to use the plugin settings screen to configure the simulation
• If using the HOOBS UI, copy and paste the example above into the 'Groups' box on the plugin settings screen
• If manually editing the config JSON, don't forget to change the first line to "groups": [

Available Options

Entry	Type	Required	Default	Explanation
deviceId	string	Yes	""	eWeLink Device ID.
label	string	No	""	This setting has no effect except to be a helpful label for identifying which device this is when editing the configuration.
type	string	Yes	""	In this case this must be set to "door".
operationTime	int	Yes	100	The time in deciseconds that the door takes to open/close. Must be 20 or more.
ipAddress	string	No	""	You can manually set the IP address for this device if it cannot be discovered by the plugin.
overrideLogging	bool	No	"default"	Override global logging setting for this device. Can be default (follows global setting), standard for standard logging, debug for debug logging or disable to disable accessory logging.