Skip to content

Latest commit

 

History

History
101 lines (73 loc) · 3.69 KB

INSTALL.md

File metadata and controls

101 lines (73 loc) · 3.69 KB
Raw

Installing From Sources

This document presents instructions to install this branch of Coq. For more general installation instructions and information about known build system issues, please consult the wiki page:

https://github.com/coq/coq/wiki#coq-installation

Build Requirements

To compile Coq yourself, you need:

  • OCaml (version >= 4.05.0) (This version of Coq has been tested up to OCaml 4.11.1)

  • The ZArith library >= 1.10

  • The findlib library (version >= 1.8.0)

  • GNU Make (version >= 3.81)

  • a C compiler

  • an IEEE-754 compliant architecture with rounding to nearest ties to even as default rounding mode (most architectures should work nowadays)

  • for CoqIDE, the lablgtk3-sourceview3 library (version >= 3.1.0), and the corresponding GTK 3.x libraries, as of today (gtk+3 >= 3.18 and gtksourceview3 >= 3.18)

Primitive floating-point numbers require IEEE-754 compliance (Require Import Floats). Common sources of incompatibility are checked at configure time, preventing compilation. In the unlikely event an incompatibility remains undetected, using Floats would enable proving False on this architecture.

Note that OCaml dependencies (zarith and lablgtk3-sourceview3 at this moment) must be properly registered with findlib/ocamlfind since Coq's build system uses findlib to locate them.

Debian / Ubuntu users can get the necessary system packages for CoqIDE with:

$ sudo apt-get install libgtksourceview-3.0-dev

Opam (https://opam.ocaml.org/) is recommended to install OCaml and the corresponding packages.

$ opam switch create coq 4.11.1+flambda
$ eval $(opam env)
$ opam install ocamlfind zarith lablgtk3-sourceview3

should get you a reasonable OCaml environment to compile Coq. See the OPAM documentation for more help.

Nix users can also get all the required dependencies by running:

$ nix-shell

Advanced users may want to experiment with the OCaml Flambda compiler as way to improve the performance of Coq. In order to profit from Flambda, a special build of the OCaml compiler that has the Flambda optimizer enabled must be installed. For OPAM users, this amounts to installing a compiler switch ending in +flambda, such as 4.07.1+flambda. For other users, YMMV. Once ocamlopt -config reports that Flambda is available, some further optimization options can be used; see the entry about -flambda-opts in the build guide for more details.

Build and Installation Procedure

Coq offers the choice of two build systems, an experimental one based on Dune, and the standard makefile-based one.

Please see INSTALL.make.md for build and installation instructions using make. If you wish to experiment with the Dune-based system see the dune guide for developers.

Run-time dependencies of native compilation

The OCaml compiler and findlib are build-time dependencies, but also run-time dependencies if you wish to use the native compiler.

OCaml toolchain advisory

When loading plugins or vo files, you should make sure that these were compiled with the same OCaml setup (version, flags, dependencies...) as Coq. Distribution of pre-compiled plugins and .vo files is only possible if users are guaranteed to have the same Coq version compiled with the same OCaml toolchain. An OCaml setup mismatch is the most probable cause for an Error while loading ...: implementation mismatch on ....