help Jyers Marlin E3V2-Default-v4.2.2

[rvelez07]

hello, I installed Jyers Marlin E3V2-Default-v4.2.2-v2.0.1.bin, directly on top of the original ender firmware, but in the icon where the info is, info continues to appear instead of leveling, could you help or I will have to install a version earlier than V.2.0.1?

[mccolister1017]

flash the screen too

[rvelez07]

mccolister1017, Yes me flash the screen too, info continues to appear instead of leveling,
If I put version 1.2.3, will I not ruin the printer?

[mccolister1017]

this is the bl touch version it depend of your motherboard check it on your printer E3V2-UBL-BLTouch-15x15-v4.2.2-v2.0.1.bin and this is the version without BL touch E3V2-ManualMesh-5x5-v4.2.2-v2.0.1.bin

[mccolister1017]

first version if you got a BL Touch installer and the second if there is nothing on your printer like its factory .

[rvelez07]

so I can install the E3V2-ManualMesh-5x5-v4.2.2-v2.0.1.bin over the E3V2-Default-v4.2.2-v2.0.1.bin, yes, just the card or do I have to install it on the display? Thank you has been very patient with me.

[mccolister1017]

so I can install the E3V2-ManualMesh-5x5-v4.2.2-v2.0.1.bin over the E3V2-Default-v4.2.2-v2.0.1.bin, yes, just the card or do I have to install it on the display? Thank you has been very patient with me.

You can flash everything just do it correctly.