Alarm / Alarmo turn_off not found...

[jq-yeraz]

Cloos your work on bubblecard is amazing. I love this card ! I have a little issue when using Alarmo with a "button" card type and a "switch" button type. When calling the default "toggle" action, I get the following error :

Action alarm_control_panel.turn_off not found

Just another question do you think it's possible to swap between protected area with the current button or do you think you need to create an "alarm" card type instead ?

Jerome

[MrBearPresident]

The alarm_control_panel does not have a turn_on/turn_off. (source)
You instead have to use:

tap_action:
  action: call-service
  target:
    entity_id: alarm_control_panel.alarmo
  service: alarm_control_panel.alarm_disarm

---

^{If this solves your problem mark this as the solution and close the discussion.}

[jq-yeraz]

Ok but in this case, it's not possible to toggle between arm/disarm with the same button and select the area to use.

[MrBearPresident]

You could have a sub-button for arm and a sub-button for disarm.
Then hide one of the 2 with the conditional visibility that came out in v2.3.1.
If you are unable to run v2.3.3 because your browser becomes unstable. Then you'll have to wait until next release. Because Cloos has solved the problem.
.
Another solution is to use a input_boolean.toggle helper and an automation to sync the alarm - > helper and helper - > alarm.
Then you can toggle the helper in the bubble-card.