-
Notifications
You must be signed in to change notification settings - Fork 69
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Lower Cost #50
Comments
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Here is a 5*5 PCB using Sparkfun PCB it can be changed and rebranded as
long as we follow the
Released under the Creative Commons Attribution Share-Alike 4.0 License
it brings down the costfrom 50-60$ to about 13-15
$ .
AS well as remove pullups to 3.3v . as arduino nano is 5v logic
This is only cost saving I am not going to make and sell It saves 35$ off the BOM .
I can produce Gerbers and Pick & Place if Needed.
Note I am using JLCPCB with a low setup cost I am not using a Local Israeli company. If
we have a 500$ NPI the idea is useless. JLCPCB is Limited at 50 PCBS 1250 pcbs.
One can purchase the boards from Aliexpress for about 17-20$ but unknown quality and may
be fake.
https://jlcpcb.com/smt-assembly
Arie
The text was updated successfully, but these errors were encountered: